How to Replace Leak Detection Pump 2004-06 Jeep Liberty
Created on: 2014-01-17
Follow along with this video to learn how to replace the leak detection pump on your 04-06 Jeep Liberty.
-
step 1 :Removing the Leak Detection Pump
- Remove the two 10mm nuts from the leak detection pump
- Remove the red clip on the wiring harness with a flat blade screwdriver
- Twist the hoses and pull them free from the detection pump
- Remove the pump from its bracket
-
step 2 :Installing the New Leak Detection Pump
- Push the bracket into the detection pump
- Push the two hoses onto the pump
- Place the detection pump back onto the studs
- Insert and tighten the 10mm nuts
- Reconnect the pump harness and push the red clip up
Tools needed
-
Flat Blade Screwdriver
10mm Socket
Ratchet
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and the next time you need a part for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the leak detection pump on this 2006 Jeep Liberty with the 3.7 liter V6 engine. It's the same part and process on these vehicles from 2004 to 2006. The items you'll need for this repair include a new leak detection pump from 1AAuto.com, a 10mm socket and ratchet, a flat blade screwdriver, and a vice helps but isn't necessary.
Your leak detection pump is located right here. You want to start off by removing these two 10mm nuts. We'll just fast-forward as Don does this. Then, using a flat blade screwdriver, pry that red clip down and pull the harness free. Then pull the hoses free. Just move them back and forth and eventually they'll pull free. Now, you don't need to use a vice here, but this bracket can be pretty hard to get out of here. You just need something to secure it while you pull it free.
On the right is the old leak detection pump; on the left is the new one from 1A Auto. You can see they're identical and will mount exactly the same.
Push the bracket onto your new leak detection pump. Reattach the two hoses. Then push the detection pump back up onto those studs. We'll just fast-forward as Don replaces those two 10mm nuts and tightens them up. Reconnect your harness and push the red clip up, and you're all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
Shop Products
Check Engine Light EVAP Flow During Non-Purge Condition - Code P0496
Watch this video to learn how to diagnose and fix a check engine code P0496
